Governor
A governor, or speed limiter or controller, is a device used to
measure and regulate the speed of a machine, such as an engine.
Other Applications - Mopeds
Other Applications - Public services vehicles
Mopeds in the United Kingdom have had to have a 30 mph (48 km/h)
speed limiter since 1977. Most other European countries have
similar rules.
Urban public buses often have speed governors which are typically
set to between 65 kilometres per hour (40 mph) and 100 kilometres
per hour (62 mph).
Public service vehicles often have a legislated top speed.
Scheduled coach services in the United kingdom (and also bus
services) are limited to 65 mph.
Machines Applicable:
We provide governor for basically all high speed packing machines
while the one in photos is for GDX2 cigarette packing machine.
Function:
Electrical generator - droop speed control
For electrical generation on synchronous electrical grids prime
mover's drive electrical generators which are electrically coupled
to any other generators on the grid.
Droop speed control:
Droop speed control is a control mode used for AC electrical power
generators, whereby the power output of a generator reduces as the
line frequency increases. It is commonly used as the speed control
mode of the governor of a prime mover driving a synchronous
generator connected to an electrical grid. It works by controlling
the rate of power produced by the prime mover according to the grid
frequency.
Mechanism:
This permits the ratio of power used to vary depending on load, so
for example, base load generators will generate a larger proportion
at low demand. Stability requires that over the operating frequency
range the power output is a monotonically decreasing function of
frequency.
Droop speed control can also be used by grid storage systems. With
droop speed control those systems will remove energy from the grid
at higher than average frequencies, and supply it at lower
frequencies.
Customization:
Electromagnetic clutch shown in pictures are for Molins Mark8
cigarette making machines. Please provide detailed info. to us if
your desired specs is different.
Depending on machine models and other factors, time needed for
manufacturing can vary. Thus details of product and relative lead
time must be negotiated beforehand to avoid any discordance.
Other Services:
Before business actually starts, we are always glad to send you
samples(wear parts/ consumables/ spares) for a quality test.
Clients are always welcome to our office for better communication,
and also to our plants for an on-site inspection. Please inform us
of your journey beforehand so that we could meet you at the airport
and join you to visit our plants.
We provide on-site engineering support for installation of complete
machines if requested.
For requirement of specific certification to meet import
regulations of certain nations, inform us beforehand to get our
products certified if they are not yet.
Payment Terms:
Payment terms are negotiable under following principles:
For products we have in stock, normally we ask for full payment
upon ordering.
For products of customized specification, or painted as required,
or of special materials, normally we ask for full payment upon
ordering.
For regular size wear parts/ consumables/ spares, normally we
request 30% payment before sending order to our plant, and the
balance before shipment.
